Kit buying instructions for South America

Purchase the microcontroller board

Please order either a Stellaris Launchpad (EK-LM4F120XL) or a Tiva Launchpad (EK-TM4C123GXL) from one of the distributors listed below or one of the distributors listed on the Worldwide page. All the projects we will develop in these course will run on both these microcontroller boards. The boards may or may not be available at the regional distributors listed below.

Extra electronic parts

You can order the extra electronic parts for this class either from the Worldwide page or from one of the local distributors listed below.

Please make sure to order the following:
  • 1 Solderless breadboard (400+ holes) + wires
  • 2 Green through hole LED's (1.6V-2V,2mA or less)
  • 2 Red through hole LED's (1.6V-2V,2mA or less)
  • 2 Yellow through hole LED's (1.6V-2V,2mA or less)
  • 6 470ohm 1/4W 5% resistors (1/2W or less, 10% or less)
  • 1 1Kohm 1/4W 5% resistor (1/2W or less, 10% or less)
  • 3 1.5Kohm 1/4W 5% resistors (1/2W or less, 10% or less)
  • 3 12Kohm 1/4W 5% resistors (1/2W or less, 10% or less)
  • 4 10Kohm 1/4W 5% resistors (1/2W or less, 10% or less)
  • 4 Push button switches (B3F tactile, breadboard-able)
  • 1 Mono or stereo headphone jack (breadboard compatible)
  • 1 Slide potentiometer (5-50K, breadboardable, 1-5cm slide)


Brazil
Chile
Chile
Colombia
Colombia
Ecuador
Peru
Venezuela

Regional Distributors sourced from www.seeedstudio.com